Home Technical Support The Hot Seat The Hot Seat How do I install The Hot Seat so that it runs on a network?

How do I install The Hot Seat so that it runs on a network?

Hits:
1641
Rating:
 
Vote for this:
Good - Bad

Answer

The Hot Seat can be configured as a network installation by following the instructions below:
  1. Install The Hot Seat to your network folder and register the software.
  2. Open the folder in which The Hot Seat was installed.
  3. Set the Read-only attribute of the file THS.DXR to True.
  4. Open the Binary folder.
  5. Set the Read-only attribute for the following files to TRUE: 

    • Behaviours2.cxt
    • LCLib1_06.cxt
    • RegLib.dxr
Trackback(0)
Comments (0)add
feedSubscribe to this comment's feed
Write comment

busy